|
Speed Controller SLW-CONTROLLER1 Installation and Wiring |
|
| Rated Voltage | 24 Volts |
| Rated For Motors | Up To 350 Watts |
| Maximum Current | 25 Amps |
| Rated For Chargers | Up To 3 Amps |
| Conversion Efficiency | 95% |
| Under Voltage Protection | 20.5 Volts |
| Recommended Fuse Size | 30 Amps |
| Dimensions | 3-1/4" x 2-9/16" x 1-1/2" |
| Under Voltage Battery Protection:
When the battery pack falls below a specific Voltage the controller
turns the motor off preventing over discharging of the battery pack
which extends the battery packs lifespan. (The cutoff value is
approximately 20.5 Volts ± 1.0 Volts) Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. The motor turns on again after the brakes are released. Note About Connectors: |
|
*Power Connector
|
|
| Motor
Connector
|
 Required Connection |
| Throttle
Connector
|
 Required Connection |
Power
Switch Connector Mating Connector Item # CNX-51 |
 Required Connection |
|
Battery Charger Connector
|
 ~Optional Connection |
| Brake
Lever Switch Connector Mating Connector Item # CNX-51 |
 ~Optional Connection |
|
*The power connector
should be the last connection made. *Fuse or circuit breaker protection is required between speed controller and battery pack. ~Optional Connections do not need to be hooked up for the speed controller to operate. |