|
Speed Controller SPD-24350G Installation and Wiring |
|
| Rated Voltage | 24 Volts |
| Rated For Motors | Up To 350 Watts |
| Maximum Current | 25 Amps |
| Conversion Efficiency | 95% |
| Under Voltage Protection | 20 Volts ± 0.5V |
| Recommended Fuse Size | 30 Amps |
| Dimensions | 3" x 2-3/8" x 1-3/8" |
| Under Voltage Battery Protection:
When the battery pack falls below a specific Voltage the controller
turns the motor off preventing over discharging of the battery pack
which extends the battery packs lifespan. (The cutoff value is
20 Volts ± 0.5 Volts) Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. The motor turns on again after the brakes are released. |
|
*Power Connector Red = Positive Black = Negative Mating Connector Item # CNX-50 |
 Required Connection |
|---|---|
|
Motor Connector Green = Positive Yellow = Negative Mating Connector Item # CNX-50 |
 Required Connection |
|
Throttle Connector Mating Connector Item # CNX-52 |
 Required Connection |
|
Brake Lever Switch Connector Mating Connector Item # CNX-51 |
 ~Optional Connection |
|
Speed Meter Connector Green = Positive  Mating Connector Item # CNX-09S |
~Optional Connection |
|
Speed Limit Connector Mating Connector Item # CNX-62 |
Connect for High Speed, Disconnect for Slow Speed |
|
*The power connector
should be the last connection made. *Power switch and fuse or circuit breaker is required between speed controller and battery pack. ~Optional Connections do not need to be hooked up for the speed controller to operate. |