Speed Controller SPD-361000E Installation and Wiring

Rated Voltage   36 Volts
Rated For Motors   Up To 1000 Watts
Maximum Current   60 Amps
Conversion Efficiency   95%
Under Voltage Protection   30.5 Volts ± 1 Volt
Recommended Fuse/Circuit Breaker   60 Amp
Dimensions   5-1/2" x 4" x 2"
Thick Wire Length   6"
Thin Wire Length   4"
Shared Thick Red Wire: The thick red wire is shared between the battery pack or motor.

Requires Heavy-Duty Switch or Power Contactor: This controller does not have a built in power relay to turn it on and off. A heavy-duty power disconnect switch such as item # SWT-700 or SWT-705 or power contactor such as item # RLY-24150 is needed to turn this controller on and off.

Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 30.5 Volts ± 1.0 Volts)

*Battery and Motor Wires

Black = Negative to Battery

Red = Shared Positive

Green = Negative to Motor

10 Gauge Stranded Copper Wire


Required Connection

**Throttle Connector
Red = +5 Volts Output

Black = Negative

Green = 1-4 Volts Input Signal

Mating Connector Item # CNX-52
Required Connection
*The battery pack should be the last connection made.
*Fuse or circuit breaker protection and power switch or power contactor are required between the speed controller and the battery pack.
*Power switch or contactor and fuse or circuit breaker connects to the red wire between the speed controller and battery pack.
**Requires standard 3-wire throttle to operate.