Speed Controller SPD-362000 Installation and Wiring

Rated Voltage   36 Volts
Rated For Motors   Up To 2000 Watts
Maximum Current   60 Amps
Conversion Efficiency   95%
Under Voltage Protection   30.5 Volts ± 1 Volt
Recommended Fuse/Circuit Breaker   60 Amp
Dimensions   6" x 4" x 2"
Thick Wire Length   6"
Thin Wire Length   4"
Two Thick Red Wires: The two thick red wires are connected together inside of the controller so it does not matter which thick red wires go to the battery pack or motor.

Requires Heavy-Duty Switch or Power Contactor: This controller does not have a built in power relay to turn it on and off. A heavy-duty power disconnect switch such as item # SWT-700 or SWT-705 or power contactor such as item # RLY-24150 is needed to turn this controller on and off.

Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 30.5 Volts ± 1.0 Volts)

Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. The motor turns on again after the brakes are released.

*Power Connector
Red = Positive
Black = Negative


10 Gauge Stranded Copper Wire


Required Connection

Motor Connector
Red = Positive
Blue = Negative


10 Gauge Stranded Copper Wire


Required Connection

**Throttle Connector
 Red = +5 Volts Output
Black = Negative
Green = 1-4 Volts Input Signal


Mating Connector Item # CNX-52
Required Connection
Brake Lever Connector
Black+Yellow Disconnected = Motor On
Black+Yellow Connected = Motor Off


Mating Connector Item # CNX-51
Optional Connection
*The battery pack should be the last connection made.
*Fuse or circuit breaker protection and power switch or power contactor are required between the speed controller and the battery pack.
*Power switch or contactor and fuse or circuit breaker connects to the red wire between the speed controller and battery pack.
**Requires standard 3-wire throttle to operate.