Speed Controller SPD-482400 Installation and Wiring

 THIS MODEL HAS BEEN DISCONTINUED

Rated Voltage  48 Volts
Rated For Motors  Up To 2400 Watts
Maximum Current  60 Amps
Conversion Efficiency  95%
Under Voltage Protection  41 Volts
Recommended Fuse/Circuit Breaker Size  70 Amps
Throttle  Hall Effect Throttle (standard 3 wire)
Dimensions  6-1/2" x 3-1/2" x 2"
Under Voltage Battery Protection: When the battery pack falls below a specific Voltage the controller turns the motor off preventing over discharging of the battery pack which extends the battery packs lifespan. (The cutoff value is approximately 41 Volts ± 1.0 Volts)

*Power and Motor Connection



The motor and battery connections share one common wire. The red positive lead of the controller is attached to the positive lead of the battery and the positive lead of the motor.
Hall-Effect Throttle Connector Plug
*The battery pack should be the last connection made.
*Fuse or circuit breaker protection is required between the speed controller and the battery pack.