|
Speed Controller SPD-SD1000-5 Installation and Wiring |
|
| Rated Voltage | 36 Volts |
| Rated For Motors | Up To 1000 Watts |
| Maximum Current | 40 Amps |
| Under Voltage Protection | 31 Volts ± 1.0 Volts |
| Recommended Fuse Size | 40 Amps |
|
Under Voltage Battery Protection:
When the battery pack falls below a specific Voltage the controller
turns the motor off preventing over discharging of the battery pack
which extends the battery packs lifespan. (The cutoff value is
approximately 31.0 Volts ± 1.0 Volts) Motor Cut-Off During Braking: When the brakes are applied the brake switch signals the controller to turn off the motor. This feature is optional. To disable leave brake lever switch connector unplugged. |
|
*Power Connector Mating Connector Item #CNX-2PX2
|
Required Connection |
| Motor Connector Blue = Positive Green = Negative Mating Connector Item # CNX-50 |
 Required Connection |
| Throttle/Battery Gauge Connector Throttle = Red, Black, Green Battery Gauge = Orange, Grey
Mating Connector Item # CNX-65 |
 Throttle is Required Connection ~Battery Gauge is Optional Connection |
|
Brake Lever Switch Connector
Mating Connector Item # CNX-51 |
 ~Optional Connection |
| Battery Charger Connector
Connects to positive lead of battery charger port and disables motor when the battery pack is being recharged.
Mating Connector Item # CNX-45 |
 ~Optional Connection |
|
*The power connector should be the last connection made.
*Fuse or circuit breaker protection is required between speed controller and battery pack. ~Optional Connections do not need to be hooked up for the speed controller to operate. |