|
Speed Controller SPD-SD1000-6 Installation and Wiring |
|
| Rated Voltage | 36 Volts |
| Rated For Motors | Up To 1000 Watts |
| Maximum Current | 40 Amps |
| Under Voltage Protection | 31 Volts ± 1.0 Volts |
| Recommended Fuse Size | 40 Amps |
|
Under Voltage Battery Protection:
When the battery pack falls below a specific Voltage the controller
turns the motor off preventing over discharging of the battery pack
which extends the battery packs lifespan. (The cutoff value is
approximately 31 Volts ± 1.0 Volts) Motor Cut-Off During Braking: When the brakes are engaged the brake switch signals the controller to turn off the motor. |
|
*Power Connector
Mating Connector Item # CNX-2PX2 |
|
| Motor Connector
Blue = Positive Green = Negative Mating Connector Item #CNX-50 |
Required Connection |
| Throttle Connector
Mating Throttle Item # THR-600 |
 Required Connection |
| Brake Lever Switch Connector
Mating Connector Item # CNX-51 |
 ~Optional Connection |
|
Charger Port Connector Connect to positive lead of battery charger port. Prevents motor from operating when battery pack is charging.
Mating Connector Item # CNX-45 |
 ~Optional Connection |
|
*The power connector
should be the last connection made. *Fuse or circuit breaker protection is required between speed controller and battery pack. ~Optional Connections do not need to be hooked up for the speed controller to operate. |